Nussbaum UNI-LIFT 2500, Инструкция по эксплуатации и документация

Страница: 17 / 45

Operating Instruction and Documentation
UNI-LIFT 2500
- 17 -
It is necessary to lubricate in regular intervals. In the case of usual use of the automotive-lift we
recommend monthly lubrication intervals. In the case of strong demand of the automotive-lift
the lubrication intervals must be shortened accordingly.
Recommended lubricants:
Grease: each commercial grease e.g..
! Attention: Do not use greases with fixed lubricants (e.g. graphite, Mos2) use.
Lubrication spray: trade-usual lubrication sprays
! Attention: Do not use lubrication spray with silicon parts .
• Check the electrical parts, electric cables and channels for Damage.
• Check all welded joints for cracks on the automotive-lift.
If any cracks are found on the lift cease use immediately. Switch-off and secure the main
switch (lock) and call the service partner.
• Check the function and condition of the safety ratchets. Grease the sliding surfaces.
• Damage to external surfaces, must be immediately repaired.
If theses repairs are not made immediately, permanent damage to the powder-coated
surface may result.
Repair and clean damaged areas with an abrasive paper (grain 120). After this is complete,
use a suitable paint (observe the RAL Number).
• Check the zinc surface and repair it with a suitable tool. Use abrasive paper (grain 280).
White rust can result from moisture laying in certain areas for long periods of time. Poor
aerating can also result in rust formation.
Rust may result from mechanical damage, wear, aggressive sediments (de-icing salt, liquids)
or insufficient cleaning.
Repair and clean these areas with abrasive paper (grain 280).
After this is complete, use a suitable paint (observe the RAL Number).
• Examine the hydraulic lines for leakage (visual check).
Life time of hydraulic hoses:
The use duration of the hose lines should not exceed six years, including a storage time of
two years.
• The hydraulic oil has to be changed at least once a year. To change the oil, lower the lift into
its lowest position. Empty all tanks and refill with clean oil, approx. 11 litres per hydraulic unit
are needed.
Use an ATF-Suffix hydraulic-oil (OEST Company) if the ambient temperature is under 5
degrees centigrade. After filling, the hydraulic oil must be between the upper and lower
markings of the oil level gauge.
Remove the old oil according to the appropriate regulations.
• Check that all screws and bolts are correctly torque (turning moments, see the list Pic. 6)
Pic 5:
7.2 How often must the lift be cleaned?