Nussbaum TOP LIFT TSK 12000 DJ, Руководство по эксплуатации, журнал осмотров

Страница: 32 / 56

Operating Manual and Inspection Book
TOP LIFT TSK 12000 DJ
- 32 -
6.2.2 Defect of the Pneumatic valve
If there is a defect on a pneumatic valve the safety latches cannot be opened.
However there is still the option of opening the valve using a hand pump or
compressor.
1.
Open the top cover of the external unit.
2. Remove the blue pneumatic hose coming from the lift at the pneumatic
valve. (see Fig. 2b).
3. This air hose must be connected to a hand pump or compressor. The re-
quired operating pressure to unlock is 6 to a max. 10 bars.
4. Push the "Lower" button and lower the lift until the lowest position is reached.
5. If the lift cannot be lowered, push the "Lift" button briefly until the latch is re-
leased. Push the "Lower" button again until the lift has reached the lowest
position.
Lowering
11.
The entire lowering process must be continuously observed.
12. Once the lift is at the lowest position, the vehicle can be driven off the lift.
13. The lift must be stopped until defective parts have been exchanges and the
lift is in a technical perfect condition again.
14. If required, do maintenance.
6.2.3 Defect of the hydraulic valve, defect of the Pneumatic valve,
or in case of power failure
If there is a defect in the hydraulic valve, a defect pneumatic valve or in the
case of a power failure there is still the option of moving the lift to its lowest posi-
tion so the vehicle can be drive off the lift.
1.
Open the top cover of the external unit.
2. Remove the blue pneumatic hose coming from the lift at the pneumatic
valve. (see Fig. 2b).
3. This air hose must be connected to a hand pump or compressor. The re-
quired operating pressure to unlock is 6 to a max. 10 bars.
4. The latches must unlock.
5. If the safety latches are locked, they must be lifted with a suitable tool (hyd.
lifter) if needed until the safety latch opens due to the attached com-
pressed air.
6. Unscrew the cap on the hydraulic valve (see Fig. 2a).
7. Open the hydraulic valve to start the lowering procedure.
Lowering
8.
The entire lowering process must be continuously observed.
9. Once the lift is at the lowest position, the vehicle can be driven off the lift.
10. The lift must be stopped until defective parts have been exchanges and
the lift is in a technical perfect condition again.
11. If required, do maintenance.