Nuova Mondial Mec MANTA COMPAT 200 LX, Инструкция пользователя и руководство по обслуживанию, Страница: 60 / 87

Page 60 of 87
301009_R00_IT
10.5.7 PREPARATION AND COMMISSIONING
10.5.7.1 Preliminary checks
Before starting up the machine, you must perform a series of checks and controls to prevent
errors or accidents during commissioning.
- Provide appropriate space for storage both for pieces to be processed, and for those already
processed (possibly also using appropriate containers).
- Do not perform any work operation or intervention on the rear side of the machine without it being
turned off from the power supply.
- Do not come close to the work surface during the execution of the normal work cycle of the machine
- Ensure the free movement and the eventual free rotation of all moving parts.
- Check that the hydraulic connections are tight so as not to cause leakage and uncontrolled water
sprays.
10.5.8 Operating Modes
As mentioned in Chapter 7 (Description of the Machine), there are 2 versions of the MANTA COMPAT
machine, meaning with two control and operation modes:
1) Manual control mode
2) Semi-automatic control mode with motorized axes.
10.5.9 Commissioning
10.5.9.1 Version No. 1 - Manual:
The electrical panel of the machine is constituted in such a manner as to have both start and stop
switch in the immediate vicinity of the operator position (REF. Q
Errore. L'origine riferimento non è
stata trovata. ).
After making all the preparations and adjustments for the piece cut, press the start button [ON] (REF.
B
Errore. L'origine riferimento non è stata trovata.Errore. L'origine riferimento non è stata
trovata. ). The electrical system is made so that in case there is a power failure the machine shutdown
occurs safely, when the power returns there is no immediate start, but you need to press the start
button again.
The arrest of the machine is achieved by pressing the red push emergency stop button 0 [OFF] (REF.
A
Errore. L'origine riferimento non è stata trovata. .)
Wait for the emission of water from the coolant system on the cutting disc, adjusting the flow
required using the shut-off valve located above the disc blade protection.
To perform the safe cutting of the pieces, it is necessary to pull the carriage, and then the cutting
blade against the workpiece.
Grip the handle of the head on the drive hand wheel and rotate it clockwise (REF.V
Errore. L'origine
riferimento non è stata trovata. ) continuously without breaks, maintaining the correct working
position with respect to the machine and the piece you wish to cut out, see paragraph "Workstations".
The cutting direction must be made in a concordant sense, therefore equal to the direction of rotation
of the disc, so as to press the piece on the support surface.
In case of excessive resistance of the transfer, or the slowing down or locking of the disc blade on the
piece, slow or stop the progress of the disk and then resume the cut gradually.
If during the cutting of hard materials you experience unnecessary strain on the engine thus causing a
slowdown in the rotation of the disk, it is recommended to make the cut in several passes by gradually