1
- Buckle the vehicle belt. Both the shoulder
AND
lap belt must be under the vehicle belt lock off
and belts must lay flat.
2
- While pressing the base into the vehicle seat
(1)
, tighten the vehicle belt by pulling straight
along the belt path
(2)
.
3
- While the shoulder belt is tight, hook the
bottom of the vehicle belt lock off
(1)
and press
to close
(2)
.
If vehicle only has a lap belt, then put lap belt under
vehicle belt lock off.
Additional stability can be achieved with the base
by using the stability leg. For instructions on using
the stability leg see stability leg section.
Check the installation
Belts must be tight.
Base should not move side to side more than
1” at belt path.
Bubble must be touching line.
Belts and buckles must not interfere with
attachment of child restraint to base.
Vehicle belts must lay flat under vehicle belt
lock off.
It is acceptable to install with both LATCH
(lower attachments) and the vehicle belt.
1
1
2
2
1
2
3
39
PIPA lite series instructions
38
PIPA lite series instructions