44
T 01460 68600
Information for Scrubber Dryer
As with all electrical equipment care and attention must be exercised at all times during its use, in addition to ensuring that routine and
preventative maintenance is carried out periodically in order to ensure its safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard could render this equipment unsafe
and the manufacturer can accept no responsibility or liability in this respect. When ordering spare parts always quote the Model Number / Serial
Number specified on the Rating Plate.
Warning do not use on slopes exceeding 2%.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance. When detergents or other liquids are used, read the manufacturer’s instructions.
Only use brushes provided with the appliance or those specified in the instruction manual. The use of other brushes may impair safety. A full range of brushes
and accessories are available for this product. Only use brushes or pads which are suitable for the correct operation of the machine for the specific task being
performed.
It is essential that this equipment is correctly assembled and operated in accordance with current safety regulations. When using the equipment always ensure
that all necessary precautions are taken to guarantee the safety of the operator and any other persons who may be affected.
Wear nonslip footwear when scrubbing. Use a respiratory mask in dusty environments. The machine, while charging, must be positioned so that the mains
plug is easily accessible.
When cleaning, servicing or maintaining the machine, replacing parts or converting to another function the power source shall be switched off.
Mains operated machines shall be disconnected by removing the power plug, and battery operated machines shall be disconnected by removing the fuse.
In order to prevent unauthorised use of the machine the power key must be removed after use. Machines left unattended shall be secured against unintentional
movement.
When detergents or other liquids are used, read the manufacturer’s instructions. Operators shall be adequately instructed as to the correct use of the machine.
If this product does not have a factory installed Numatic battery charger, then it is the responsibility of the owner and user of the product to ensure that the
charging system and battery combination are compatible, fit for purpose and safe to use.
This machine is not suitable for picking-up hazardous dust.
Do not use on surfaces having a gradient exceeding that marked on the appliance.
This machine shall be stored indoors only
This machine is for indoor use only.
Read the instruction manual before using the appliance.
This product meets the requirements of IEC 60335-2-72
NOTE: This machine is also suitable for commercial use, for example in hotels, schools, hospitals, factories, shops and offices for other than normal housekeeping
purposes.
• Ensure only competent persons unpack/assemble the machine.
• Keep your machine clean.
• Keep your brushes in good condition.
• Replace any worn or damaged parts immediately.
• Regularly examine the power cord for damage, such as cracking or ageing. If damage is found, replace the cord before further use.
• Only replace the power cord with the correct Numatic approved replacement parts.
• Ensure that the work area is clear of obstructions and / or people.
• Ensure that the working area is well illuminated.
• Pre-sweep the area to be cleaned.
• Use steam cleaners or pressure washers to clean the machine or use in the rain.
• Attempt machine maintenance or cleaning unless the power plug has been removed from the supply outlet.
• Allow any inexperienced repairs. Call the experts.
• Strain cable or try to unplug by pulling on cable.
• Leave the brush pad on the machine when not in use.
• Allow the machine to be used by inexperienced or unauthorised operators or without appropriate training.
• Use the machine without the solution tanks properly positioned on the machine, as shown in the instructions.
• Expect the machine to provide trouble-free, reliable operation unless maintained correctly.
• Run the machine over power cable during operation.
• Lift or pull the machine by any of the operating triggers, use the main handle.
• Remove the handle from the machine except for service and repair.
WARNING
CAUTION
DO
DON’T
ORIGINAL INSTRUCTIONS
READ MANUAL BEFORE USE
1. Always wear protective clothing e.g. face visor, gloves and overalls when working with batteries.
2. Whenever possible always use a properly designated and well-ventilated area for charging. Do not smoke or bring naked flames into the charging area.
3. Remove any metallic items from hands, wrists and neck i.e. rings, chains etc. before working on a battery.
4. Never rest tools or metallic objects on top of the battery.
5. When charging is complete disconnect from the mains supply.
6. The batteries must be removed from the machine before it is scrapped.
7. The machine must be disconnected from the supply when removing the battery.
8. To remove the batteries:- Disconnect machine from the mains supply (if charging) and ensure batteries are switched off with circuit disconnect switch. Disconnect
hoses from separator and tanks. Remove separator and tanks. Unscrew battery strap fixings and remove. Undo battery terminals and remove. Remove batteries.
9. The batteries are to be disposed of safely, as according to local government guidelines.
10. Only use genuine Numatic replacement batteries.
11. Do not allow the batteries to become fully discharged; it may not be possible to re-charge them.
Batteries should not be discharged below 9.5 volts witht10 amps flowing.
12. Do not allow one battery to be discharged separately to the other.
13. Do not mix batteries from different machines.
14. The batteries fitted to this product are Valve Regulated Lead Acid (VRLA) gel electrolyte type.
The fitting of any other type of battery may cause a safety hazard.
15. Disconnect the fuse between the batteries before cleaning or maintenance.
Battery Care
1. Always re-charge the batteries after use. This can be done at any time its not necessary to wait until they are fully discharged;
they do not develop a “memory”.
2. Leaving the charger to operate for a minimum of 4 hours after the green light has come on, at least weekly, will prolong battery life.
3. Do not store the machine with the batteries discharged.
Precautions when working with batteries
TwinT
ec
Maintenance
Содержание TGB 6055
Страница 53: ...53 T 01460 68600 EU Declaration of Conformity...
Страница 54: ...54 T 01460 68600 Schematic Diagram Notes...
Страница 55: ...55 T 01460 68600 Notes...