OPERATOR & MAINTENANCE MANUAL
34
Warning:
Avoid injury! The radiator will be hot and can burn skin. Built-up pressure may
cause explosive release of coolant when the radiator cap is removed. Shut off engine
and allow to cool. Do not remove cap unless the radiator and the engine are cool to
touch with bare hands. Slowly loosen the cap to the first stop to release all pressure.
Then remove cap.
6.5 Engine Oil and Oil Filter
6.5.1 Change engine oil
①
Open the oil drain ball valve.
②
Open the access door.
③
Open sump and oil ball valve, located
beneath the oil pump.
④
Use the oil pump to drain the engine oil.
⑤
After draining, close the oil and oil drain ball valves.
⑥
Loosen and remove the oil inlet cap, through
an outside oil filter add oil into the oil inlet
until the level is slightly less than the upper
limit.
⑦
Tighten the oil inlet cap and close the access
door.
6.5.2 Change oil filter
①
Fully drain the engine oil, as described in 6.5.1.
②
Loosen and remove the oil filter.
③
Add engine oil into a new oil filter.
④
Lubricate the new gasket with oil.
⑤
Screw the new filter into place and tighten it until the
gasket contacts the seal surface.
⑥
Add engine oil as described in 6.5.1.
