NuFlo MC-II Plus Panel Mount, Руководство пользователя

Страница: 74 / 92

MC-II Plus WP-PM Flow Analyzer
Appendix D
D-2 May 2005
Prompt
Where
Displayed
Definition
CodE Upper line The display prompts to enable or disable the
requirement for a security code by toggling the
on or
oFF selection shown on the lower line of the display.
div d.P Upper line When USEr defined unit of measure was previously
selected, the display prompts for entry of the pulses
per unit volume decimal point. The present decimal
point placement is shown on the lower line of the
display.
Ent div Upper line When USEr defined unit of measure was previously
selected, the display prompts for entry of the divisor
in pulses per unit volume. The present divisor is
displayed on the lower line of the display.
Ent F Upper line When MCF was previously selected for the volume
units of measure, the display prompts for the entry of
the average flowing temperature in degrees
Fahrenheit. The present flowing temperature entry is
displayed on the lower line of the display.
Ent FPv Upper line When MCF was previously selected for the volume
units of measure, the display prompts for the entry of
the average supercompressibility factor (Fpv). The
presently entered super-compressibility factor is
shown on the lower line of the display. (Enter
1.00000 if supercompressibility factor is not known)
Ent.CodE Upper line The display prompts for the entry of a 4-digit security
code to be entered on the lower line of the display
(only if the
CodE function is enabled).
Ent.P.ACF Upper line When MCF was previously selected for units of
measure, the display prompts for the entry of the
meter factor in pulses per actual cubic foot. The
present meter factor entry is displayed on the lower
line of the display.
Ent.P.gAL Upper line When the volume units of liquid measure were
previously selected (BBL, GAL M3), the display
prompts for entry of the meter factor in pulses per
gallon. The present meter factor entry is displayed
on the lower line of the display.
Ent.PSig Upper line When MCF was previously selected for the volume
units of measure, the display prompts for the entry of
the average flowing pressure in Pounds per Square
Inch. The average flowing pressure entry is
displayed on the lower line of the display.
Error Lower line Is displayed when there is an error detected by the
MC-II
Plus firmware. Pressing any key while in the
Run Mode will display the type of error on the upper
line of the display.