NuFlo MC-II Plus Panel Mount, Руководство пользователя

Страница: 23 / 92

MC-II Plus WP-PM Flow Analyzer
May 2005 17
displayed by showing Prog no on the upper line of the display and the firmware
version on the lower line of the display.
2. After the diagnostics routine is complete, the upper line of the display will show
the prompt tot Eng . Pressing INCR will select the engineering units of
measurement from BBL, GAL, M³, MCF, which are displayed on the right side of
the display or
USEr on the lower line of the display (factory default is BBL).
Press INCR until USEr is selected. Press ENTER to confirm the selection.
3. The MC-II Plus Flow Analyzer show the prompt tot d.P on the upper line of the
display and zeros with a decimal point on the lower line of the display (factory
default is 0.0). This prompt is requesting the decimal point position for the volume
display. Repeatedly pressing the
INCR key will move the decimal point from 0.0
to 0.00 to 0.000 to 0 and return to 0.0. Press the INCR key until 0.0 is displayed.
Press the ENTER key.
4. The upper line of the display of the MC-II
Plus Flow Analyzer will show the
prompt SEt tot with either yES or no on the lower line of the display prompting
for a decision if a preprogrammed volume is to be entered (factory default is no ).
Since no preprogrammed volume is to be entered, press INCR to toggle between
yES or no until no is displayed. Press ENTER . (See the section Presetting
Volume to preset a volume.)
5. The upper line of the display will show the prompt div d.P . The available
selections are 0.0, 0.00, 0.000 and 0 (factory default is 0.00). Since the divisor is
786,437, the 0 position, for whole number only, is selected. Press
INCR until 0 is
shown on the lower line of the display. Press ENTER .
6. The upper line of the display will show Ent div which is prompting for the entry of
the divisor. The lower line of the display will show the previously entered meter
factor (factory default is 230.00). The right-most digit (the ones position) will be
blinking, indicating it is the digit currently selected for editing. Remember to enter
the divisor calculated for units of registration regardless of the location of the
volume decimal point set in Step 3.
Since 7 is to be entered in this position (factor of 786,437) press
INCR until 7 is
displayed. (Remember that if the desired digit is accidentally passed, continue to
press
INCR until that digit is displayed again.)
Press
STEP to proceed to the next digit (tens position). Press INCR until 3 is
displayed.
Press
STEP to proceed to the next digit (hundreds position). Press INCR until 4
is displayed.