2
21. 07. 20. Document Number 671954
Nuaire |
Western Industrial Estate
|
Caerphilly
|
CF83 1NA
|
nuaire.co.uk
XBC+ with Ecosmart Connect (C) Control
Installation Manual
1.2 Important Information
This manual contains important information on the safe and
appropriate assembly, transport, commissioning, operation,
maintenance, disassembly and simple troubleshooting of the product.
While the product has been manufactured according to the accepted
rules of current technology, there is still a danger of personal injury or
damage to equipment if the following general safety instructions and
the warnings contained in these instructions are not complied with.
•
Read these instructions completely and thoroughly before
working with the product.
•
Keep these instructions in a location where they are accessible
to all users at all times.
•
Always include the operating instructions when you pass the
product on to third parties.
1.3 Personal Protective Equipment
The following minimum Personal Protective Equipment (PPE) is
recommended when interacting with Nuaire product:
•
Protective Steel Toed Shoes -
when handling heavy objects.
•
Full Finger Gloves (Marigold PU800 or equivalent) -
when
handling sheet metal components.
•
Semi Fingerless Gloves (Marigold PU3000 3DO or equivalent)
- when conducting light work on the unit requiring tactile
dexterity.
•
Safety Glasses
- when conducting any cleaning/cutting operation
or exchanging filters.
•
Reusable Half Mask Respirators
- when replacing filters which
have been in contact with normal room or environmental air.
Nuaire would always recommend a site specific risk assessment by a
competent person to determine if any additional PPE is required.
2.0 INTRODUCTION
The information contained in this document provides details of
installation, operation and maintenance for installers and users of the
XBOXER XBC Supply and Extract Ventilation Unit with Heat Recovery.
This supply and extract air handling unit range comprises an
combination of high efficiency centrifugal fans with EC motors, a
Counterflow design plate heat exchanger, filters, optional heaters
(LPHW and Electric) and a casing with high mass acoustic treatment.
A range of matched, close coupled attenuators with a similar
construction method to that of the unit is available. The attenuators
can be flipped for positioning on the left or right of the fan unit
(Figure 1) allowing flexibility for duct layout.
Attenuators are available in 1050, 1250 and 1600mm lengths and a
matching attenuator flange is attached to the fan unit.
General information regarding performance and specifications for
the equipment may be obtained from our Technical Literature, and/or
project specific documentation.
XBC Unit
Room Side Extract / Supply Attenuator:
1050 / 1250 / 1600mm long (optional)
and Pump *
Access to Intake Filter /
Fan / Condensate tray
Atmospheric side Intake / Discharge Attenuator:
1050 / 1250 / 160
0 mm long (optional)
Access to Controls *
Access to Coil bleed and drain /
Valve / Valve Actuator /
Electric Heater Elements *
Access to Extract FIlter / Fan *
Factory Fitted Attenuator Flange
Blanking Panel (Flange Must Be
Rotated 180° If Using Alternative
Silencer Arrangement)
Attenuator / Flange Connector
Attenuator / Flange Connector
*Unlock an access panel by inserting a flat head screwdriver
into the locking latch and turning anti-clockwise (1/4 turn).
Note: Bottom access unit (BA) Filters cannot be accessed
from the side of the unit.
1
Unit Layout Overview
