NTI VEEMUX AUDIO VIDEO MATRIX SWITCH VIA CAT5
30
Telnet Interface-Port 2005
For a software control type of telnet interface session (versus operator telnet control through port 2000 as described on page 29),
connect to the VEEMUX through the current IP address at port 2005. Use the command set below to control and acquire
information from the VEEMUX.
Note: After establishing the connection, the unit will answer with a blinking prompt on the next line. If the connection
fails it will answer with ?<CR>
Legend
: (All numbers must be two digits)
OP
:
Output Port (01-MAXOUTPUTS)
IP
:
Input Port (01-MAXINPUTS)
<CR>
:
Carriage Return (Hex 0xD)
Command Summary
Command String
Good Response
Description
RU<CR>
ru
I
P,
O
P<CR>
Read unit size
RO OP<CR>
pc OP,IP<CR>
Read connection for OP
CS
I
P,
O
P<CR>
*<CR>
Connect OP to IP
CA IP<CR>
*<CR>
Connect all outputs to IP
SS 01<CR>
*<CR>
Enable auto-status mode
SS 00<CR>
*<CR>
Disable auto-status mode
SX<CR>
See details
Examine connections
XX<CR> *<CR>
Close
connection
A <CR> (carriage return, 0x0D) is considered to be the end of the command string. If a string exceeds 16 characters, an end of
string will be inserted automatically to avoid buffer overflow. An eventual <LF> (line feed, new line, 0x0A) after a <CR> will be
ignored. A bad string will always be responded to with the ASCII character
‘
?
’
followed by a <CR>.
