NRG INSTRUCTIONS
Windcube PV Trailer
Windcube_PVTrailer_ModerateClimate_Instructions
Rev. 2
[email protected] | Page 4
27 March 2018
Section 1: Towing and Siting
Only tow the remote power trailer with a vehicle with a minimum 3000+ lb towing capacity.
When arriving at the site, be sure to select a relatively level location, and orient the driver’s side of the trailer toward
South. The ground should be firm, but the included blocking will provide extra stability.
Figure 2: Typical towing vehicle
1.
Place a block under the tongue jack, and rotate the jack into position.
2.
Unclip the wiring, towing chains and tongue clip; disconnect the trailer hitch.
3.
Jack the trailer up clear of the towing vehicle and pull the vehicle forward.
4.
Place blocks under the rear corner jacks and engage the jacks to stabilize the trailer.
5.
Locate the side jacks and extend the driver’s side jack until it reaches the last hole. The passenger side jack is not
extended. Block both jacks and crank them down until they are holding some of the trailers weight.
6.
Use a level to adjust the trailer until it is relatively flat.
Section 2: Trailer Assembly
Items have been secured with Bungee cords, Ratchet straps, cardboard pieces and blocking. When unstrapping, be sure
to save all packing materials for future transport.
1.
Disconnect all bungee cords.
2.
Remove and retain Shipping Bracket at base of Panel Frame and the blocking from the floor (if a Windcube is
shipped inside the trailer).
3.
Remove Panel Frame from trailer.
NOTE: Install Panel Frame on trailer before unpacking solar panel.
4.
Mount Panel frame to trailer
a.
Hold in position and install two pivot bolts at the top of the PV frame to the side of the trailer.