Operating manual
LTSA LTMA
If necessary, carry out the adjustment as follows:
3.
Switch off the printer.
4.
Carefully loosen the bellows (3) at the upper end (Velcro fastener).
5.
Pull the applicator foot down so that the two motion links (A and B) are accessible.
Hold or fix the applicator foot in extended position, otherwise it will fly back at high speed into
the home position!
Adjusting the horizontal position:
6.
Unscrew motion link (A), adjust according to the table and screw tight again.
Moving motion link A towards
--> moves the pressure plate towards
top
front (distance A becomes larger)
bottom
rear (distance A becomes smaller)
Adjusting the vertical position:
7.
Unscrew motion link (B), adjust according to the table and screw tight again.
Moving motion link B towards
--> moves the pressure plate towards
top
top
bottom
bottom
8.
Switch on printer.
9.
After initialisation of the applicator, check the home position. If necessary, repeat steps 3 and 9 un-
til the home position is correctly adjusted.
In home position , the applicator must not reach the upper limit!
10.
Secure the bellows again.
11.
Switch on the printer and apply a test label.
Edition 02 - 7/2021
26
Commissioning
Setting the applicator home position
