Operating manual
LTSA LTMA
4.
Connect sub-D cable harness to the output stage board M5A as shown in the table:
Connect cable with mark
to connector
on printed circuit board
motor
J3 motor
sensor 1
J4 sensor 1
M5A output stage
aux
CN910 aux
power
CN1202
CPU Board
For further details, see Service manual XLP 50x, chapter “Appendix” > “Wiring diagrams” > “XLP
504 peripheral”.
5.
Connect ribbon cable (D) to CPU board (B, CN602) and the two output stages (A, E). Fit hinged
ferrite core (C) to the cable as illustrated.
6.
Installing the dispensing edge.
(2 screws Torx M3 x 6)
7.
Close the printer enclosure again.
Edition 02 - 7/2021
17
Commissioning
Installing conversion kit LTSA in XLP 504
