Operating manual
LTSA LTMA
SETTING THE APPLICATOR HOME POSITION
WARNING!
Risk of crushing between the applicator and dispensing edge and between the moving
parts of the applicator!
► Carry out adjustments only with the printer switched off.
► Hold or fix the applicator foot in extended position, otherwise it will fly back at high
speed into the home position - Risk of crushing!
► During trial operation: Keep your hands away from the applicator!
Before you begin
• XLP 504 with LTSA or XLP 514 with LTMA
• The settings have been carried out in the parameter menu of the XLP 504/XLP 514 (see chapter
“Settings in the parameter menu”
on page 22)
About this task
In order for the labels to slide smoothly onto the applicator pressure plate after dispensing, the home
position of the applicator pressure plate must be checked and adjusted, if necessary, after installa-
tion of the LTSA/LTMA. When viewed from the side, the pressure plate must be slightly above the dis-
pensed label (distance B) and slightly ahead of the dispensing edge (distance A).
Fig. 9: Setting the home position of the pressure plate (1). A = Horizontal distance (setpoint: 1 mm), B = Vertical distance
(setpoint: 0.5 mm).
Triggering the applicator without printing/dispensing: press the key below the
icon.
Procedure
1.
Switch on printer.
After booting of the printer and initialisation of the applicator (brief up-and-down movement), the
pressure plate is in home position.
2.
Check the position of the pressure plate (1) relative to the dispensing edge (2). If adjustment is
necessary, determine and note the necessary adjustment distance (horizontal and vertical).
Edition 02 - 7/2021
25
Commissioning
Setting the applicator home position
