Novatel SMART2 Series, Инструкция по установке и эксплуатации, Страница: 47 / 76

Chapter 6 Troubleshooting
SMART2 Installation and Operation Manual 1 47
Bit Set Action to Resolve
21
You may be exceeding the receiver’s velocity limit. If so, reduce velocity. This error can
only be cleared by resetting the receiver.
22 Reload firmware using WinLoad or the SoftLoad commands.
23-30 Reserved
31 Possible hardware failure. Contact Customer Support on page 9.
Bit Set Action to Resolve
0
Check the Error Word in the RXSTATUS log. See also Table 10: Resolving a Receiver
Error Word on the previous page
1
Check the temperature ranges in
l
SMART2 Environmental and Electrical Specifications on page 70
2 See
3
4
5
6
7
Check the CPU idle time. Check for unnecessary logging. Check for simultaneous use of
functionality.
8
See Table 7: Serial Ports Supported on page 22
Also, check the Auxiliary 2 Status word to determine which COM port has overrun its
buffer.
9-11 Reserved
15 Check the Auxiliary 1 status word to determine which RF channels are jammed.
16-17 Reserved
18
When the receiver has tracked GNSS satellites long enough for a valid almanac to be
received, this bit will be set to 0.
19 None. This bit only indicates if the receiver has calculated a position.
20
None. This bit is a status bit indicating if the receiver’s position has been manually fixed
and does not represent a problem. Refer also to the
FIX command.
21
None. This bit indicates if clock steering has been manually disabled. Refer also to the
FRESET command.
Table 11: Resolving an Error in the Receiver Status Word