Novatel SMART-MR10-GENERIC, Руководство пользователя

Страница: 91 / 104

SMART-MR10 User Manual Rev 0B 91
Appendix C Logs
C.1 Position Logs
C.1.1 NMEA Logs
The NMEA logs (receiver outputs) supported by the SMART-MR10 are summarized in Chapter 3 of
the
OEMV Family Firmware Reference Manual in section "NMEA Standard Logs". The available
logs include:
• GPGGA, which outputs a log of position system fix data and undulation. There are variants of
GPGGA, specifically:
- GPGGARTK, which has greater precision than GPGGA but with the loss of the
undulation field
- GPGGALONG, which has both greater precision and the undulation field
• GPVTG, which outputs track made good and ground speed
Each of the available NMEA standard logs is described in more detail in its own section of Chapter 3
of the
OEMV Family Firmware Reference Manual .
The steps for configuring the receiver output, through the command line are:
1. Configure the communication port using the COM command, described in Appendix B.3, COM
Configure COM Port on Page 75 . To set COM port 2 as follows:
enter the following string:
com com2 9600 n 8 1 n off on
2. Select and configure the NMEA string that you want to output. The information is described in
Chapter 3 Data Logs of the
OEMV Family Firmware Reference Manual , in the section for the
particular log. For example, to log gpgga (position system fix data and undulation) at 2 Hz, enter
the following string:
log gpgga ontime 0.5
Bit Rate 9600
Parity none
Data Bits 8
Stop Bits 1
Handshaking None
Echo Off
Break On