Novatel OEM719, Инструкция по установке и эксплуатации

Страница: 122 / 235

Chapter 8 NovAtel Firmware and Software
OEM7 Installation and Operation User Manual v4 122
a. Send S0, S5 and S7 S-Records directly to the receiver using the SOFTLOADSREC com-
mand. The S-Record must be enclosed in quotation marks:
SOFTLOADSREC "<S-RECORD>"
Data within S0 records can also be sent to the receiver by converting them to
SOFTLOADSETUP commands. Refer to the OEM7 Commands and Logs Reference
Manual for details on how to convert from S0 S-Records to SOFTLOADSETUP com-
mands.
b. S3 S-Records should be parsed and packaged into a SOFTLOADDATA command.
6. Send the SOFTLOADCOMMIT command after all data from the *.shex file has been trans-
ferred to the receiver. The SOFTLOADSTATUS log reports the status of the loading process.
Wait for a SOFTLOADSTATUS log to indicate the status is COMPLETE. The COMPLETE status or
an error is guaranteed to be output from the receiver within 300 seconds from the time the
SOFTLOADCOMMIT command was received by the receiver.
7. Send the auth code for the newly downloaded image using the AUTH command. This is only
required if there is not already a signature auth code on the receiver as signature auth codes
are maintained through a SoftLoad update. See
Authorization Code on page 115 for details
on Auth Codes.
AUTH ADD_DOWNLOAD <AUTH CODE>
8. Reset the receiver using any of the following methods:
l
Enter the RESET command
l
Enter the FRESET command
l
Power-cycle the receiver
Once the receiver resets, the new version of firmware is active.
The SoftLoad process can be safely canceled at any time using the SOFTLOADRESET command
or by otherwise resetting the receiver. Once the COMPLETE status is reported by
SOFTLOADSTATUS, the new firmware image will be run after the receiver is reset.