Novanta NDS ScaleOR, Руководство пользователя

Страница: 17 / 40

VGA S-Video / Composite
DVI-D 3G-SDI
Removable Input Modules
Input Modules:
Four types of input modules are available: DVI-D , 3G-SDI , VGA and S-Video / Composite
The DVI-D input module accepts DVI signals up to 1920 x 1200 progressive at 60Hz.
The 3G-SDI input module accepts SDI signals up to 1920 x 1080 progressive at 60Hz.
The VGA input module accepts analog signals up to 1920 x 1200 progressive at 60Hz.
The S-Video / Composite input module accepts S-Video / Composite NTSC or PAL signals .
Module Removal and Installation
The ScaleOR must be turned off prior to installing or replacing the input module.
Input Module Removal:
Use a number 1 Phillips screwdriver to loosen, but not remove, the screws located on the le and right sides of
the module moun ng plate. When the screws are clear of the chassis, remove the module by gripping the
screws and pulling the module out.
Installation:
Slide the new module into the chassis un l it contacts the connector, then push gently un l the module seats.
The module is correctly seated when the moun ng plate is flush with the back panel. Thread the screws into the
chassis un l they touch the moun ng plate, then ghten each screw by turning it another quarter turn.
9
VGA Module Switches
Function Switch 1 Switch 2 Switch 3
RGBS On On Off
YPbPr Off On Off
VGA On Off Off
SOG Off Off Off
OSM / RS-232 Off Off On
1. To select the Input Format using the OSM or via Serial
control switch 3 must be On . When switch 3 is On
switches 1 and 2 are disabled.
2. To select the input format manually turn switch 3 Off .
Then, using the table to the le , set switches 1 and 2
to the format of the input signal.
Any one of the input modules shown below may be installed in the card slot.