nosstec 8264, Руководство по эксплуатации

Страница: 9 / 24

8264 English, rev 3
9
safeTy
Cut the power
Cut the current before touching live parts. This is done either by disconnecting the main
switch of the machine or by disconnecting the voltage of the electrical cabinet.
Note: Do not put the main switch or the safety switch of the machine out of operation.
Danger zone
In connection with production work check that no part
of the body comes too close to the infeed side of the
clamping rolls of the machine (see figure).
Note: The infeed side may vary owing to the direction
of rotation of the rolls.
Keep the instruction manual of the machine in a safe place.
The instruction manual contains important information that besides the safety information also give
important information regarding operation, service, maintenance etc.
Modification of the machine
All conversion, modification or change of this machine is strictly forbidden with the exception of
• Original spare parts
• Optional equipment supplied by the manufacturer.
Airborne noise
The following noise level has been measured at the operator’s place:
Equivalent noise level Leq, idle running
66 dB(A)
Equivalent noise level Leq, operation 68 dB(A)
Falling workpieces
Be careful when working with heavy workpieces so
that they do not fall down by mistake when the grip
loosens between the bending and lower rolls (see fi-
gure). If necessary use a support table, travelling cra-
ne or some other lifting device.