nosstec 8264, Руководство по эксплуатации

Страница: 10 / 24

Operating instructiOns 8264
10
2018-09-12
safeTy
Pinching risk of the workpiece
Note that there is a pinching risk between the ends
of the workpiece, see figure.
Emergency stop
This machine is equipped with two emergency stop functions, i.e. one emergency stop on the electrical
cabinet and one emergency wire running around the machine at foot height. This together with the fact
that the machine is equipped with brake motor enables the machine to stop instantaneously in case of
injury or risk of injury no matter where you are around the machine.
Service and maintenance
Before service and maintenance are carried out on the machine you must have had instructions from
your foreman. You must also read and understand this instruction manual. Disconnect the main switch
before the service job begins. If the machine must be dismantled, completely or partly, contact your
foreman.
Protective clothing
Important! Never use gloves when bending, as this consider-
ably increases the risk of getting pinched between the rolls.
For other handling of the workpieces use gloves. The operator
must not carry belts, rings or necklaces.
Working shoes with steel inserts must be used.
Loose hanging clothes must not be used.
If the operator has long hair, this must not hang loose.
Deburring of the workpiece
Burrs and sharp edges must be removed from the workpiece before bending.
Jamming
If for some reason the machine stops while
bending a workpiece, proceed as follows:
• Crank down the bottom roll and possibly also the bending roll.
• Remove the workpiece. Identify the trouble reason. If the motor protection is released,
wait for some minutes before it is reset. The machine is then ready for use again.
• If the trouble is mechanical or electrical: Cut the current and contact the supervisor.
Pinching risk