Step 1:
Step 2:
Concealed Wired Units Only: Two (2)
NOTE:
three (3)
Step 3:
Step 4:
Concealed Wired Units Only:
Surface Wired Units Only:
Step 5:
Step 6:
Determine hand of door from illustration on Page 1.
Using template, (Page 2), locate and prepare holes in the
frame & door:
B.
7/8" (22mm) diameter
holes for conduit, for power input and for switch/sensor wires.
On new construction these holes will generally be
drilled by the frame supplier at their shop or at the time the
frame is installed in the wall.
C. Prepare
holes for 3/8" diameter sex nuts. Standard
units are supplied with sex nuts and screws for 1-3/4"
(44mm) thick door. Sex nuts and screws for other door
thicknesses are available to order.
Remove cover from the unit and set cover & cover screws
aside.
Mount unit to door frame. Select A or B below.
A.
B.
Mount track assembly to door using 3 1/4-20 screws & sex
nuts with buffer assembly toward hinge. Open part of
track to face top of door.
Insert slide arm rod into slide arm tube setting the
distance between the pinion square and the slide stud
at 13-1/2” (343). Install 9/64” hex drive socket head
screw from screw pack. (See illustration upper right)
Frame
Door
A. Prepare
holes for 1/4-20 machine screws or
No. 14 x 2-3/4" (70mm) wood screws. Blind rivet nuts (by
others) are suggested for unreinforced hollow metal frames
or for aluminum frames.
six (6)
Connect conduit to frame side
of backplate. Fasten unit to door frame (seven screws).
Fasten unit to door frame (seven
screws). Mount conduit bracket (found in screw pack) to
unit’s backplate with two screws provided. Connect wiring
conduit to bracket.
Installation Sequence
Step 7: Using an adjustable wrench, rotate pinion 45 toward
hinge, as shown below. With the arm assembly parallel
to the door, secure arm to pinion when square of the
pinion aligns with the square in the arm. Secure with
countersunk washer and 1/4-20 Flat Head Screw (with
thread lock) provided. Tighten screw with 7/16” wrench
or socket.
°
Step 8: Insert arm stud into slide block in track assembly.
Secure by pushing in on the retainer clip that extends
from the slide block in the track, until it is flush with the
slide block (see illustration below).
Component Layout
80-9357-0110-020 Rev. A
3
2
1
Attaching Arm Stud to Slide
Retainer Clip
BACKPLATE
REED SWITCH
CHAIN
RF POWER SUPPLY
(optional)
BREAKER SWITCH
OPEN / CLOSE POSITIONING ASSEMBLY
PINION EXTENSION / CLUTCH ASSEMBLY
1600 SERIES
CLOSER BODY
INVERTER
MOTOR ASSEMBLY
POWER SWITCH
9/64” HEX
DRIVE SOCKET
SCREW
SLIDE ARM
TUBE
SLIDE ARM
ROD
13-1/2
(343)
Note: Center threaded hole of slider arm should
align with seventh hole of the slider tube
SLIDE TRACK
ASSEMBLY
SLIDER
BUFFER STOP
VIEW FROM TOP OF RIGHT HAND DOOR
Pinion
“T1” POWER INPUT
TERMINAL (3-POSITION)
ACCESSORY
TERMINAL
(4-POSITION)
