80-9357-0130-020 Rev. A
2
Door Opening
Angle
Dim “A”
Dim “B”
Up to 110°
111° to 170°
12 (305)
9-1/2 (241)
13-1/4 (337)
15-3/4 (400)
General Templating Information
Fasteners for Frame
• Before beginning the installation, verify that the door frame is
properly reinforced and is well anchored in the wall.
• Concealed electrical conduit and concealed switch or sensor
wires should be pulled to the frame before proceeding.
• Unreinforced hollow metal frames and aluminum frames should
be prepared and fitted with 1/4-20 blind rivet nuts, furnished by
others.
• 1/4-20 Machine screws for hollow metal and aluminum.
• No. 14x2-3/4" (70mm) long sheet metal screws for wood.
Fasteners for Door
• 1/4-20 Machine screws.
• 3/8" diameter x 1-5/8" (41mm) long sex nut.
WARNING:
Make sure that (120V, 60Hz) input power is turned off at facility’s
circuit breaker before proceeding with installation.
main
Notes:
• All dimensions are given in inches (mm).
• Thickness recommended for reinforcements in hollow metal
doors and frames is charted at the left of this page.
• Do not scale drawing.
• Left hand door shown.
• Maximum frame reveal is 7” (178mm) for this application.
• This template information based upon use of 5" (127mm)
maximum width butt hinges or 3/4" (19mm) offset pivots. A
separate template will be supplied for other conditions.
• Conduit hole nearest to hinge is suggested for 120 VAC power
input.
Hollow Metal Door Frame Reinforcing
Frame
Material
12 Ga.
.1046
14 Ga.
.0747
16 Ga.
.0598
18 Ga.
.0478
(2.66)
(1.90)
(1.52)
(1.21)
12 Ga.
.1046
10 Ga.
.1343
10 Ga.
.1343
8 Ga.
.1644
(2.66)
(3.41)
(3.41)
(4.18)
18 Ga.
.0478
12 Ga.
.1046
12 Ga.
.1046
10 Ga.
.1343
(1.21)
(2.66)
(2.66)
(3.41)
Reinforcing
Recommended
Min. Required
Template
1-11/16
(43)
1-1/4
(32)
11/16
(17.5)
1-3/4
(44)
12-15/16
(329)
7-9/16
(192)
13-7/16
(341)
3/8
(10)
C
L Hinge or Pivot
1/4-20 Machine Screws
or No. 14 Wood Screws
(6 Places)
7/8
(22)
(Conduit Holes -
2 Places)
Dia.
Sex Nuts
(2 Places)
Frame
Rabbet
Frame
Stop/Soffit
A
13-13/16
(351)
1/2
(13)
B
5-1/4”
Min.
Clearance
11-11/16
(297)
3/8
(19)
General Templating Information
14-3/16
(360)
13-13/16
(351)
