Norton Clipper C13PE, Руководство пользователя

Страница: 13 / 36

13
Pull The Emergency Stop Switch to the UP Position.
NOTE: The Emergency Stop Switch is located on
the machine’s Console. Pull the starter grip lightly until you feel resistance,
then pull briskly. CAUTION: Do not allow the starter
grip to snap back against the engine. Return it gently
to prevent damage to the starter.
As the engine warms up, gradually move the choke
lever to the OPEN position (fully to the right)
Position the throttle control lever for the maximum
engine speed (fully to the Left).
To stop the engine, move the Throttle Control Lever fully to the Forward
Position (fully to the right), press the Emergency Stop Switch (Down Position),
and then turn the engine switch to the OFF position. Turn the fuel valve to the
OFF position.
Never transport the machine with the Fuel Valve in the ON
position. Never Store the machine with the Fuel Valve in the
ON position. Never Transport a machine with the blade
installed.
C. Water Supply
Pressurized source: Turn the water control to full "ON" when using wet
cutting blades. The required flow rate is 4-6 gallons per minute.
D. Operating the Saw
1. For blade installation instructions
see section II. Operation sub heading
A. Installing the Blade . For the engine starting instructions, see the