Nortel SMC 2450, Руководство по внедрению

Страница: 83 / 262

Installation and configuration Page 83 of 260
Secure Multimedia Controller Implementation Guide
4 Start a console terminal.
5 Press <Enter> on the console terminal to establish the connection.
The SMC login prompt appears.
6 Enter
admin
for the default login name.
7 Enter
admin
for the default password.
The Setup prompt (>> Setup#) is displayed. If the Main prompt
(>> main#) appears, the SMC is already configured. If you want to reset the
SMC to factory defaults, see “SMC software upgrades” on
page 164 .
8 At the Setup prompt, enter
new
to set up a new configuration.
9 Initialize the management subnet.
a. Enter the port number for the management subnet.
b. Enter the IP address for this port.
c. Enter the network mask for the entire management subnet.
d. Enter the cluster Management IP (MIP) address information.
The cluster MIP address must reside in the same subnet as the IP
address specified in step b.
Note: This is the IP address used to perform browser-based
administration from the management subnet.
10 To configure the Web UI, choose one of the following:
a. Enter
yes
to enable Web administration on the management subnet.
b. Enter
no
to indicate you do not want to enable Web administration.
11 Initialize the intranet subnet.
a. Enter the port number for the intranet subnet.
b. Enter the IP address for the intranet subnet.
IMPORTANT!
If you make an error after step 8 and need to restart the procedure,
press Ctrl + C. The CLI redisplays the Setup prompt and you can begin
again step 8.