Nortel Alteon OS, Справочник по командам

Страница: 34 / 382

Alteon OS Command Reference
34
„
Chapter 2: First-Time Configuration 40M2420, April 2007
Stopping and Restarting Setup Manually
Stopping Setup
To abort the Setup utility, press <Ctrl-C> during any Setup question. When you abort Setup,
the system will prompt:
Enter
n
to abort Setup, or
y
to restart the Setup program at the beginning.
Restarting Setup
You can restart the Setup utility manually at any time by entering the following command at
the administrator prompt:
Setup Part 1: Basic System Configuration
When Setup is started, the system prompts:
1. Enter
y
if you will be configuring VLANs. Otherwise enter
n
.
If you decide not to configure VLANs during this session, you can configure them later using
the configuration menus, or by restarting the Setup facility. For more information on configur-
ing VLANs, see the Alteon OS
Application Guide .
Next, the Setup utility prompts you to input basic system information.
2. Enter the year of the current date at the prompt:
Enter the last two digits of the year as a number from 00 to 99. “00” is considered 2000. To
keep the current year, press <Enter>.
Would you like to run from top again? [y/n]
# /cfg/setup
"Set Up" will walk you through the configuration of
System Date and Time, Spanning Tree, Port Speed/Mode,
VLANs, and IP interfaces. [type Ctrl-C to abort "Set Up"]
------------------------------------------------------------
Will you be configuring VLANs? [y/n]
Enter year [2007]: