Nortel 5500 series, Руководство по установке

Страница: 41 / 70

Setting IP parameters for the Nortel Ethernet Routing Switch 5500 Series 41
LED Color / Status Description
Rx Amber / blinking XFP has been installed. No Signal Detected or XFP
in Reset.
Both Off No XFP installed.
The Amber LEDs are usually only used during the boot process. Under normal
operation, Green is the only color the XFP LED should emit.
Setting IP parameters for the Nortel Ethernet Routing Switch 5500
Series
A 5500 Series Nortel Ethernet Routing Switch begins switching operations
after it has completely booted up and all software modules are initialized. To
manage the switch using Telnet or SNMP, or to perform TFTP operations,
certain IP parameters must be set. In addition, if the switch is being
connected into a stack configuration, the additional parameters necessary
for the proper stack operation must be supplied.
For more information on the console menus, and configuring the switch,
refer to the system configuration guide noted in
"Related publications" (page
12) on page 16.
For the initial set up of a switch, the following IP parameters must be
configured:
• IP address of the switch or stack
• Subnet mask
• Gateway address
The following procedures are covered for setting initial IP Parameters:
•
"Setting IP parameters using the console port and Console Menu" (page
41)
• "Setting IP Parameters using the console port and CLI" (page 45)
• "Setting IP parameters using the Web-based Management Interface"
(page 48)
• "Setting IP parameters using the UI button" (page 49)
Setting IP parameters using the console port and Console Menu
To set IP parameters using the console port and Console Menu, perform the
following tasks:
Step Action
1 Connect a terminal to the console port of the switch.
Nortel Ethernet Routing Switch 5500 Series
Installation
NN47200-300 2.00 Standard
5.0 7 July 2006
Copyright © 2005 - 2006, Nortel Networks Nortel Networks Confidential
.