Nortel 5500 series, Руководство по установке

Страница: 48 / 70

48 Installing the Nortel Ethernet Routing Switch
Setting IP parameters using the Web-based Management Interface
Note: IP parameters are changed during this procedure. Changes to
IP parameters can result in the loss of web browser connectivity to the
switch.
To set IP parameters using the Web-based Management Interface, perform
the following tasks:
Step Action
1 Using the procedure "Setting IP parameters using the UI button"
(page 49) , assign a default IP address to the switch.
2
Connect a computer to the switch through a data port using a
standard RJ-45 network cable.
3 Open a web browser on the attached computer and enter the factory
default IP address of the switch in the following format: http://<IP
Address>.
4 The main screen of the Web-based Management Interface will open.
Select Configuration > IP from the menu. This screen is illustrated
below.
IP configuration screen
5 Using the fields provided, configure the IP parameters. All fields
are divided into three columns: Configurable, In Use, and Last
BootP. The Configurable column is used to configure a new value
for the field. The In Use column represents the current value used
by the switch and the Last BootP column is used to display a value
Nortel Ethernet Routing Switch 5500 Series
Installation
NN47200-300 2.00 Standard
5.0 7 July 2006
Copyright © 2005 - 2006, Nortel Networks Nortel Networks Confidential
.