Nortel 5500 series, Руководство по установке

Страница: 45 / 70

Setting IP parameters for the Nortel Ethernet Routing Switch 5500 Series 45
10 Initial IP configuration is now complete. To continue with
configuration operations, select the appropriate menu item. To
disconnect from the switch select Logout from the main menu.
—End—
Setting IP Parameters using the console port and CLI
To set IP parameters using the console port and Command Line Interface,
perform the following tasks:
Step Action
1 Connect a terminal to the console port of the switch.
Any terminal or PC with an appropriate terminal emulator can be
used as the management station.
" Terminal emulation settings"
(page 45)" Terminal emulation settings" (page 45) lists the
parameters that must be used with any terminal emulation software
used to connect to the switch.
Terminal emulation settings
Property Value
Baud Rate 9600 bps
Data Bits 8
Stop Bits 1
Parity None
Flow Control None
A console cable and connector to match the male DTE connector
(DB-9) on the switch is required to connect the terminal to the switch
console port.
2 Set the terminal protocol on the terminal or terminal emulation
program to VT100 and VT100/ANSI.
3
Connect to the switch using the terminal or terminal emulation
application.
4 After the Nortel banner is displayed, press CTRL + Y to display the
main menu. The version of the main menu displayed is dependent
on whether the switch is part of a standalone or stacked switch
configuration.
"Standalone switch main menu" (page 46)"Standalone
switch main menu" (page 46) illustrates the main menu for a
standalone configuration and "Stacked switch main menu" (page
Nortel Ethernet Routing Switch 5500 Series
Installation
NN47200-300 2.00 Standard
5.0 7 July 2006
Copyright © 2005 - 2006, Nortel Networks Nortel Networks Confidential
.