Nortel 425 series, Руководство CLI, Страница: 397 / 526

Steps 397
Add the client ports:
5510-48T(config)# interface fastEthernet 3-5
5510-48T(config-if)# nsna dynamic voip-vlans 240
5510-48T(config-if)# exit
Enabling NSNA globally
5510-48T(config)# nsna enable
Configure the Nortel SNAS
To configure the Nortel SNAS, perform the following steps:
1.
“Performing initial setup” (page 397)
2.
“Completing initial setup” (page 398)
3.
“Adding the network access devices ” (page 399)
4.
“Mapping the VLANs” (page 401)
5.
“Enabling the network access devices ” (page 401)
Performing initial setup
Establish a serial console connection to the Nortel SNAS device. The
Setup utility launches automatically on startup.
Alteon iSD NSNAS
Hardware platform: 4050
Software version: x.x
-------------------------------------------------------
[Setup Menu]
join - Join an existing cluster
new - Initialize host as a new installation
boot - Boot menu
info - Information menu
exit - Exit [global command, always available]
>> Setup# new
Setup will guide you through the initial configuration.
Enter port number for the management interface [1-4]: 1
Enter IP address for this machine (on management
interface): 10.40.40.2
Enter network mask [255.255.255.0]: <mask>
Enter VLAN tag id (or zero for no VLAN) [0]:
Enter default gateway IP address (or blank to skip):
10.40.40.1
Enter the Management IP (MIP) address: 10.40.40.3
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007, 2008 Nortel Networks
.