NANOQUEST USER GUIDE
Issue 02
2-5
Fitting the Cover
2.5.3.
Once the NanoQuest has been fitted and wired, the cover can be fitted as follows:
Hook the two tabs at the top of the cover over the top of the backplate, engaging them with the
1.
corresponding slots in the backplate.
Hinge the cover over the NanoQuest body until it is correctly seated over it (clicks into place).
2.
Insert the cover retaining screw in the base of the unit and tighten.
3.
Power Up and Confidence Check
2.6
Apply power to the unit and check that the LED lights up red.
Present a Master Card once to the face of the unit and check that the buzzer gives two short beeps
and the LED blinks green and then continue to flash red. Wait 30 seconds. The buzzer should give
two short beeps and the LED returns to a steady Red.
Press the Free Exit Button, if fitted. The NanoQuest will give a short beep, the lock will release for 3
seconds and the LED changes to green during this period. This indicates that the unit is functioning
correctly.
1
2
3
