NANOQUEST USER GUIDE
Issue 02
9-1
Miscellaneous Features
9.
General
9.1
Previous sections have described the main features of NanoQuest. There are however several
additional features available to allow an administrator to overcome problems and to change the
functionality of the NanoQuest. Care must be taken when carrying out these tasks as vital information
can be lost.
Deleting all User Cards and Auxiliary Cards
9.2
Provided that the original cards are available, User Cards and Auxiliary cards can be deleted from
the NanoQuest individually as described in section 3.6. Where it is necessary to delete a card from
the system because it has been lost or stolen, the only means of deleting it individually is to use an
‘administration’ card (captive copy of the card supplied with the original) . However, if cards were
purchased without the administration pack, the only option would be to delete all cards from Nano
-
Quest and add all valid cards once again as they are available. This may be carried out either by
temporarily collecting in all cards or by an administrator adding the cards as each user attempts to
enter the restricted area.
Procedure for Deleting all Cards
9.2.1.
Description
Action
Indication
Final State
1) Enter ‘Programming Mode’
mode by presenting the Master
once.
The LED blinks green and the
unit beeps twice to indicate
programming mode has been
entered successfully.
The LED flashes red regularly
to indicate Programming Mode
1.
x1
x2
x1
Followed by a pause.
Sequence is repeated.
2) Press and hold the ‘Request
to Exit’ button for at least ten
seconds. (If the ‘Request to
Exit’ button isn’t fitted, connect
the white/black wire to ground
for at least 10 seconds).
After ten seconds, the unit will
output a long beep. Release
the button.
After 10 seconds:
(Operating mode)
