NANOQUEST USER GUIDE
Issue 02
3-1
Basic Configuration of the NanoQuest
3.
Once the physical installation of the NanoQuest is complete, User cards must be added and the unit
must be configured so that the functions operate according to the specific application.
Programming Modes
3.1
Two Master cards are supplied with the NanoQuest. These must be kept safe as they are required to enable
programming. By presenting a Master card to the reader, you can enter the programming modes.
There are nine programming modes, the first of which is entered by presenting the Master card to the
NanoQuest once (buzzer gives 2 short beeps and LED flashes green). While in this mode, the LED
flashes red. Subsequent presentations of the Master card will step through the other programming
modes. The buzzer will beep once and the LED will flash green to confirm each step.
While in programming mode, the LED indicate the current mode by a sequence of red
flashes followed by a pause. The sequence is repeated continuously while in that mode.
The number of flashes in the sequence corresponds with the programming function
number as shown in the table below.
Note:
The unit will return to Operating Mode after 30 seconds of inactivity. The unit can also be
returned to Operating Mode by presenting a Master card after a value has been set in any of
the Programming Modes.
The following table is a summary of how the programming modes function:
Programming
Function
Present
Master
Programming Operations/Actions
Default
Value
1
Add user card(s)
Once
Present card(s) to make valid
2
Add Aux. card(s)
Twice
Present card(s) to make valid
3
Delete card(s)
3 times
Present card(s) to delete
4
Add 2nd Master
4 times
Present unregistered card
5
Configure alarm
Output
5 times
Set to Latch - present a User card once
Set to Pulse - present a User card twice
Latch
6
Configure aux.
Output
6 times
Set to Latch - present a User card once
Set to Pulse - present a User card twice
Latch
7
Use door contact
7 times
Not used - present a User card once
Used - present a User card twice
Not
used
8
Silent mode
8 times
Off - present a User card once
On - present a User card twice
Off
9
Set relay strike
time
9 times
Present a User card once per second of strike time.
For 0.5 seconds present a User card 11 times. For
latching mode present a User card 12 times.
3 sec’s
Example 1 -
To add card ‘N’ as a User card:
Present a Master card once, present card ‘N’, present the Master card once again.
Example 2 –
Set to buzzer to ‘Silent Mode’ using valid card ‘V’:
Present a Master card 8 times, present card ‘V’ twice, present the Master card once again.
The rest of this section provides a full explanation of each of the basic programming functions.
