Nordson MicroMax 1, Руководство пользователя

Страница: 29 / 66

Operation
4‐1
E
2013 Nordson Corporation
All rights reserved
MicroMax
Issued 12/13
P/N 768635_11
Section 4
Operation
WARNING: Allow only qualified personnel to perform the
following tasks. Observe and follow the safety instructions in this
document and all other related documentation.
1. Turn on the supply to the control panel.
2. Turn on the panel isolator.
3. Start the fan.
4. If a powder re‐cycle system is fitted, turn on the controls and ensure
correct operation especially that the fluidising air to the hopper has
been turned on and adjusted to allow the powder to bubble gently.
5. Turn on the lights.
6. Operate the powder spray equipment in accordance with the
manufacturers instructions.
WARNING: Always ensure when cleaning the booth or
application equipment that the fan is running and appropriate
Personal Protective Equipment is worn.
7. Shutdown the booth by reversing the above sequence.
8. To empty the booth hopper to a waste bucket, connect the output of
the transfer pump located at the base of the hopper to the waste
bucket. Connect the vent from the hopper back into the booth using
the spigot supplied. Operate the empty switch until the bucket is full.
Dispose of the waste material according to local regulations.
WARNING: The MicroMax internal sieve should not have more
than 10Kgs of powder laid on top. The Maximum pressure of the
vibrator should not exceed 3 Bar, Otherwise the life of the
vibrator can be dramatically reduced
1. Daily Startup and
Shutdown