Nordson MicroMax 1, Руководство пользователя

Страница: 33 / 66

Maintenance
5‐1
E
2013 Nordson Corporation
All rights reserved
MicroMax
Issued 12/13
P/N 768635_11
Section 5
Maintenance
WARNING: Allow only qualified personnel to perform the
following tasks. Observe and follow the safety instructions in this
document and all other related documentation.
WARNING: Breathing in certain airborne dusts (including
finishing powders) may be hazardous to health. Ask the powder
manufacturer for a Material Safety Data Sheet (MSDS) for
information. Use appropriate respiratory protection.
S
Visually check the complete system for leaks, rectify.
S
Check the operation of any powder transfer systems.
S
At Least every hour press the filter cleaning pulse button located on
the main control panel.
S
Every four (4) hours, with the fan operating, clean the booth interior
with a rubber squeegee, or other non‐sparking cleaning device, pulling
the powder into the hopper section of the booth.
S
Every four (4) hours or less check the feeder hopper for powder level.
Before adding powder use the vacuum cleaner to prevent powder dust
from getting out into the room.
S
Every four (4) hours check the powder pump and gun, clean according
to the product manual.
S
Every four (4) hours clean U.V. detector lenses if fitted.
S
Every four (4) hours run the cartridge cleaning sequencer for at least
ten (10) minutes, longer if necessary, to maintain air flow.
1. Daily Maintenance