Nordson MicroMax 1, Руководство пользователя

Страница: 24 / 66

Installation
3‐2
E
2013 Nordson Corporation
All rights reserved
MicroMax
Issued 12/13
P/N 768635_11
WARNING: Allow only qualified personnel to perform the
installation. Observe safety instructions.
1. Check all electrical and pneumatic connections.
2. Check that the overload setting for the motor is set to a value
appropriate for the motor in use.
3. Start the fan and check operation of the fan contacter. Check the fan
for correct direction of rotation.
4. Set timer on airflow switch circuit to 5-8 seconds.
5. Check operation of the airflow switch. This is used to interlock the
application equipment supply and should only be on when the fan is
running.
6. Set all regulators to zero, ensure that the service air line has been
drained before opening the valve to the control panel. Check for air
leaks, remedy as necessary.
7. Set the pulse air pressure to 4.5 bar.
8. Check operation of the booth light.
WARNING: The following steps describe procedures for
seasoning of new cartridge filters. These steps must be followed
whenever 'new' cartridges are installed. Failure to properly
season cartridges can result in early clogging filter media and
loss of use.
6. Setting up the Unit
7. Using New Cartridges