9
11. The Transmitter (69) requires two AAA bat-
teries (not included); alkaline batteries are
recommended.
Remove the battery cover from the front of the
Transmitter (69), and insert batteries into the bat-
tery compartment.
Make sure that the batteries
are oriented as shown by the diagrams inside
the battery compartment.
Then, reattach the
battery cover.
Remove the adhesive backing from the Hook
and Loop Fasteners (68). Press a Fastener onto
the Frame (1) in the indicated location.
Orient the Transmitter (69) as shown. Press
the other Fastener (68) onto the back of the
Transmitter.
Attach the Transmitter (69) to the Frame (1)
using the Hook and Loop Fasteners (68).
69
68
1
Battery
Cover
11
12
12. Plug the Reed Switch (67) into the Transmitter
(69).
Insert the other end of the Reed Switch (67) into
the Clamp (62).
Rotate the Flywheel (33) until the Magnet (70) is
aligned with the end of the Reed Switch (67).
Move the Reed Switch (67) so that the gap
between the Reed Switch and the Magnet (70) is
about 1/8 in. (3 mm).
69
67
33
13.
Make sure that all parts are properly tightened before you use the exercise bike.
Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise bike to protect the floor.
62
70
