background image

HIIT Bike

ASSEMBLY INSTRUCTIONS

For Installation assistance or missing parts, please call CORE Health & Fitness at 1(800) 503-1221

Document # 620-8582 Rev. B

PAGE 1 OF 2

STEP 3: 

Slide the user left side handlebar onto the bike 

then use a 6mm allen key to secure the handlebar to the 

frame using one (1) piece each of the M8 x 20mm screw 

and M8 Belleville washer. Cover with the supplied cap. 

Repeat this step for the user right side handlebar.

STEP 2: 

Use a 5mm allen key to secure the mast to the 

frame using three (3) pieces each of the M8 x 16mm 

screws and M8 washers. Repeat this step for the other 

side of the mast

STEP 1: 

Connect the RPM sensor lower cable to the upper 

cable, slide the beauty ring onto the mast, then slide the mast 

down onto the frame of the bike. NOTE: The other connection 

port on the adapter cable is only used when using an AC wall 

power adapter for the HIIT Console.

.

STEP 4: 

Finish installing the user left side handlebar 

using a 35mm open-ended wrench to secure one (1) 

piece of the M24 Axle Nut. Repeat this step for the user 

right side handlebar.

STEP 5: 

Slide the user left foot peg onto the bike, then 

secure it using a 13mm socket and two (2) pieces each of 

the M8 x 16mm hex head screws and M8 washers. 

Repeat this step for the user right side foot peg.

STEP 6: 

Install the user left side pedal, then using a 

14mm socket, torque the pedal bolt to 33-37 Lb-Ft (45-50 

Nm). Repeat this step for the user right side pedal.

STEP 7: 

Slide the seat post sleeve onto the seat post 

then loosen and pull the height adjustment pin while 

sliding the seat post into the bike frame. Finally secure 

the seat post sleeve using a #3 phillips screwdriver to 

tighten two (2) pieces of the M4 x 8mm screws.

LR14 1.5V

Отзывы: