w w w . h a w k e y e e l e c t r o n i c s . c o m
A.
Using a pencil, mark the mounting holes in the Housing.
Check behind the desired mounting location for any cables or
wiring that could be damaged during drilling. You will have to
supply your own screws, so make certain that the length of
screw that you have chosen will not penetrate an undesirable
location (through the bottom, side, top, etc of the vessel). Drill
and install screws through the Housing mounting holes into
the drilled holes.
B.
Using an alcohol solution, clean both the DSM and the
Mounting Location. Apply a marine grade adhesive or tape
that is resistant to gas and oil, to the back of the housing and
press it against the mounting location.
C.
Use Zip-Ties to secure the Housing to a solid surface.
STEP 3
Installing the Audible Alarm Assembly
N
OTICE
:
Make certain that the desired mounting location allows for
access to the back of the Alarm Housing (A) when it is installed
as you will have to install the Nut (B) from the back. Please
keep in mind that the cable from the Alarm Housing to the electronics
box must reach the desired mounting location.
1. Find a location on the vessel that will allow the audible
alarm to be heard by the operator under ALL operating
conditions. Mark that location with a pencil.
2. Check behind the desired mounting location for any
cables or wiring that could be damaged during
Installation and secure them out of the way.
3. Using the 19/32” (15 mm) drill bit, drill the hole for the
Alarm Housing (A).
4. Remove the Nut (
B
) from the Alarm Housing (
A
) and
Cable Assembly (
C
).
5. Seal any penetration into wood with a marine sealant.
6. Insert the Plug (
C
) through the hole you just drilled, and press the Alarm
Housing into the hole until it is flush against the mounting surface.
7. Access the back of the Alarm Housing from below the mounting surface and
install the Nut (
B
), turning clockwise until it is tight and the Alarm Housing
does not rotate.
