w w w . h a w k e y e e l e c t r o n i c s . c o m
Allow the adhesive to cure as per the manufacturer’s instructions.
N
OTICE
:
Try to align the transducer
so that the point is aimed
at the bow of the vessel.
STEP 4
Routing the Cable
1. After the adhesive has cured, route the cable the mounting location of the
depth sounder transducer plug. To reduce electrical interference, separate
the transducer cable from other electrical wiring. Coil any excess cable and
secure it in place using tie-wraps.
2. Plug the cable into the corresponding cable on the
Digital Depth Sounder display.
STEP 5
Testing and Troubleshooting the Glue-In Installation
N
OTICE
:
High Speed performance of the depth sounder may require
extensive adjustment and testing to find the best transducer
mounting location. This transducer has been tested to perform up
to 60 MPH (97 KPH) in an In-Hull application. Not all boat hull configurations
will allow for this type of performance. If you are not satisfied with the
performance of the depth sounder, it is recommended that you seek the
advice of a professional marine electronics installer.
To Test Your Transducer Installation:
1. Make sure that the display is functioning properly by following the display
testing procedures in the Display Installation and Operation Manual.
2. Place the vessel in the water. Once the display is turned ON, it will display
the test sequence and then display the current depth.
