w w w . h a w k e y e e l e c t r o n i c s . c o m
STEP 2
Assembling the Transom Mount Bracket
1. With the Locking Tab in the up position, align the
transducer and bracket, then slide the transducer
into the Pivot Bracket until it cannot slide any
further
(minimal force is required) (illustration A).
2. Press the Locking Tab down against the Pivot
Bracket until it locks firmly into place.
3. Slide the Pivot Bracket arms through the back of
Screw Bracket as pictured.
(illustration B).
4. Grasp the transducer in your hand as shown in the
picture to the right. Rest the screw bracket against
a solid object (ground) and press the Pivot Bracket
into the Screw Bracket with enough force until it
snaps into place
(illustration C).
N
OTICE
:
To unlock the locking tab
use a flat head screwdriver
to pry the tab up.
STEP 3
Mounting the Transom Mount Bracket
1. Locate Transom Template inserted in this manual.
2. At the desired mounting location, position the
template so the arrow at the bottom is aligned with
the bottom edge of the vessel making certain that
the template is parallel to the waterline of the
vessel.
3. Using a 9/64" (4 mm) drill bit, drill two holes 7/8" (22
mm) deep at the locations indicated on the
template marked with an "X".
A
B
C
D
