w w w . h a w k e y e e l e c t r o n i c s . c o m
STEP 1
Mark & Drill the Holes
1. Find a location on the vessel that will allow
clear viewing of the display. Keep in mind that
the wires for the DSM must reach the mounting
location of the display.
2. Lay the Display Mounting Bracket against the
mounting locationand using a pencil, mark
mounting holes (
A,
B
).
3. Drill (2) 1/16” (2 mm) holes at location
A
.
4. Drill (1) 1/2” (12 MM) hole at location
B
.
Install the Display
1. Insert the Display Cable (
D
) into the
hole
B
.
2. Install and fasten the Display
Mounting Bracket (
C
) by installing
the supplied (2) #2 x 3/8” Stainless
Steel Screws in the holes labeled
A
.
3. Feed the remaining Display Cable
(
D
) through the Cable Pass Through
(
B
).
4. Secure the Display Housing (
E
) to
the Display Mounting Bracket (
C
) by
aligning the Mounting Tabs (
F
) with
the notches on the back of the
Display and pressing securely
together.
STEP 2
Installing the Digital Depth Sounder Module (DSM)
1. The mounting location for the DSM must not
allow exposure to excessive heat or submersion
in bilge water. Also, make certain that the
cables for the Transducer and Display reach the
desired mounting location.
2. There are several ways to mount the
Electronics Housing. Be certain that the
installation that you choose is secure and will
not allow the housing to move around.
