26
4.7
E
LECTRICAL
I
NSTALLATION
1.
Install the UC4+ Control Panel (
E01
) in
the cab of the sprayer. Mount the panel
where it will be clearly visible and within
easy reach of the operator.
A good spot to mount the UC4+
control panel is on the right hand side
of the cab to the Roll Over Protection
Bar. Four pilot holes for the screws
provided need to be drilled to facilitate
the control panel mounting.
If desired, a mounting bracket (part
#A53255) can be purchased from your
local John Deere dealer to allow the
UC4+ control panel to be mounted to
the existing John Deere terminal mount.
Another option is to purchase an
adapter for the flexible panel mount that
has a 3/8" NC threaded stud on the end
to bolt through the existing JD mount.
You can find these at your local
outdoor store as a RAM mount part
number RAM-B-236. (See
http://www.ram-mount.com/
)
Figure 29: Control Panel Mounting
Figure 30: JD Control Panel Mounting
ROP
Содержание UC4 Plus Rogator 64 Series
