Nolan N64, Инструкции по безопасности и эксплуатации

Страница: 9 / 52

9
INSTRUCTIONS FOR USE
• VISOR
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 Press and hold the visor release button (A) down and slide the visor forward until it clicks (Fig. 1).
1.3 Free the visor hooks (B1 and B2) from their housing.
1.4 Follow the same steps on the other side of the helmet.
Attention: do not remove the visor mechanisms from the shell.
2 ASSEMBLY
2.1 Set the visor in open position by placing the visor hooks (B1 and B2) in line with the housings in the
visor mechanism (Fig. 2).
2.2 Insert hook B1 in the housing provided and press the visor against the shell in line with hook B2.
This will actuate the visor release button (Fig. 2).
2.3 Slide the visor until the visor locks into place.
2.4 Follow the same steps on the other side of the helmet.
ATTENTION!
- After each assembly or disassembly procedure of the different parts, check that the visor mechanism
works properly by pulling the visor up and down; if necessary, repeat the above described steps.
- If the visor pulling-up/-down mechanisms get damaged or malfunction, refer to a Nolan authorised
dealer.
• REMOVABLE INNER COMFORT PADDING
(Only for versions with removable inner padding)
1 DISASSEMBLY OF THE CHEEK PAD
1.1 Unfasten the chin strap (see instructions).
1.2 Take hold of the rear part of the left cheek pad and pull towards the inside of the helmet to undo the
snap fastener (Fig. 3).
1.3 Release the flap near the internal chin guard (Fig. 4).
1.4 Repeat the previous operations for the right cheek pad.
2 LINER FITTING
2.1 Unhook the left rear flap from the support fixed to the inner shell by slightly deforming the shell sea-
ling edge and slightly pulling the comfort padding in the helmet neck-ring area towards the inside
(Fig. 5). Follow the same steps to remove the central and right rear flap.
2.2 Unhook the left front flap from the support fixed to the inner shell by slightly puling the comfort pad-
ding towards the inside of the helmet (Fig. 6). Follow the same steps to remove the central and right
front flap.
2.3 Remove the inner comfort padding from the helmet.
3 ASSEMBLY LINER
3.1 Properly insert the comfort padding into the helmet.
3.2 Hook the front fastening flaps to the support fixed to the inner shell by slightly pushing the liner
towards the outside of the helmet (Fig. 6).
3.3 Hook the rear fastening flaps of the inner comfort padding to the seats in the helmet neck-ring area
(Fig. 5). To carry out this step, slightly deform the sealing edge of the shell and push until the faste-
nings click. Take care to stretch the liner so that it adheres to the inner polystyrene.