B3
13
Fig. 30
Fig. 31
Position the comfort padding in its housing (see specific instructions provided in the helmet user
manual), hooking the neck roll (Fig. 30).
Position both the comfort cheek pads in their housing (see specific instructions provided in the
helmet user manual) making sure that all the press-studs click.
Note
: Carefully check the proper final positioning of the cheek pad, pulling the chinstrap toward the
inside of the helmet and testing the press-studs.
Caution:
Make sure that there are no cables sticking out of the helmet and that the loudspeakers are in
their housing.
Caution
: Always verify the proper length of the chinstrap and adjust it as necessary, once again referring
to the specific helmet instructions.
Position the e-box in the relevant housing. First insert the front part, then press down on the e-box
until both hooks fully click. To remove the e-box, press the two sliding hooks at the same time until
the e-box comes out.
Warning
: Do not leave the helmet exposed to atmospheric agents without the e-box or the protection
plate provided with the helmet.
4.
REMOVING THE SYSTEM
Fig. 32
To remove the system from the helmet,
remove the earphone and the comfort cheek
pads as shown in the assembly operations.
Then remove the polystyrene cheek pads.
Remove the protection plate, then, looking at
the helmet from the outside, release the
connector by acting on the fastening clasp as
illustrated in the figure.
After releasing the connector from the shell, also remove the right part by releasing the battery
holder.
Now remove the entire system from the helmet.
