16
Note:
If a Bluetooth device (mobile phone or GPS) equipped with music player with Bluetooth A2DP
player has already been paired up, the pairing up DOES NOT have to be repeated as the A2DP
protocol has already been stored in the B3.
Once the Bluetooth device has been paired up, connection is automatic when the system is turned on.
In case connection is not automatically initiated after a few seconds, you can connect from the Bluetooth
device or by pressing “
on
” for 4 seconds.
6.1.
Affiliation reset function
You can remove all affiliated devices from the system memory. This operation is not reversible; right
after resetting, you will have to repeat the affiliation procedure for the cell phone (or for other
compatible Bluetooth devices).
To erase all devices previously affiliated, proceed as follows:
Press “
on
” and keep it pressed (for more than 4 seconds), until the LEDs start to flash quickly and
you hear a sharp beep in the headset, indicating the “Pair-up mode”;
Press “
” and “
” at the same time for 4 seconds, and release them when you hear a beep. The N-
Com will emit a special acoustic signal to confirm and will then turn itself off.
This function can also be turned on through PC using the “N-Com Wizard” programme.
7.
MOBILE PHONE FUNCTIONS
Answering a phone call
Briefly press any key when you hear the incoming call signal
Hanging up/rejecting a
phone call
Press “
on
” and keep it pressed for about 2 seconds (until you hear the
acoustic signal)
Voice call (if equipped)
Press “
on
” and keep it pressed for about 4 seconds (until you hear the
acoustic signal)
Redial last number
Briefly press “
” and “
” at the same time
Transferring a call from
helmet to mobile phone
To transfer an ongoing call from the helmet to the mobile phone, press
both “
” and “
” at the same time and keep them pressed for 4 seconds
Conference call function
B3 allows a conference call with Rider and Pillion Passenger.
When a call comes in on a mobile phone connected via Bluetooth to B3, the Rider-Pillion Passenger
intercom is temporarily turned off. However, if you wish to share the phone call with the other helmet,
simply turn on the intercom manually during the phone call (by briefly pressing “
on
”).
Caution
: this function is available only if the Pillion Passenger helmet is also equipped with a N-Com
system provided with the same function.
If you are using the “Universal Intercom”, you need to check whether the other intercom supports
the Conference feature.
