Nokia IP561, Руководство по установке, Страница: 50 / 96

Connecting PMC Network Interface Cards
50 Nokia IP561 Security Platform Installation Guide
Four-Port 10/100 Ethernet NIC
The IP561 supports Nokia-approved, four-port UTP5 dual-mode (10-Mbps and 100-Mbps)
Ethernet NICs installed in a PMC expansion slot. When you purchase a 10/100 Ethernet NIC
with your IP561, the NIC is installed before the appliance is delivered to you. For information
about how to add or replace a NIC, see
Chapter 4, “Installing and Replacing Network Interface
Cards.”
10/100 Ethernet NIC Features
The four-port 10/100 Ethernet NIC supports PCI operation at 133 MHz and runs on Nokia
IPSO-VN v4.1 or higher.
In the IP561, the four-port Ethernet NIC supports the following features:
„
High bandwidth
„
Full-duplex mode operation up to 100 Mbps
„
Link speed auto advertising (10/100)
„
Cable autosensing
„
PCI operation at 133 MHz
„
Compliance with IEEE 802.3ab Gigabit Ethernet specifications
You can configure and monitor Ethernet NIC interfaces by using Nokia Network Voyager.
Specifically, you set the port speed and full-duplex or half-duplex mode with Network Voyager.
For information about how to access Network Voyager and the related reference materials, see
“Using Nokia Network Voyager” on page 40.
Figure 10 Four-Port 10/100 Ethernet NIC Front Panel Details
After the power is turned on and the cables are connected, the Ethernet link LEDs on both the
IP561 and on the remote equipment illuminate to indicate the connection. As data is transmitted,
the activity LEDs on the appliance illuminate.
Ethernet NIC Connectors and Cables
The Ethernet connectors on the four-port 10/100 Ethernet NICs are RJ-45 connectors. Use a
straight-through or crossover cable to connect the NIC to a 10-Mbps or 100-Mbps hub or switch
00026.3
3 2 1
1
2
3
4
4
1000 BaseT
Link LEDs (solid green)
Activity LEDs (blinking green)
Ports