Nokia IP100 Series, Руководство по установке

Страница: 45 / 106

IP100 Series Installation Guide 31
Using System Startup
If you select Option 1, go on to the next section, Step 4—Entering
Initial Interface Information. Skip the rest of the present section.
Option 2 (Lynx) allows you to use Lynx to configure the NAP. Lynx is a
text-based browser that runs on the console itself. Lynx is supplied as part
of the IPSO software. Use Lynx only if you cannot connect to a LAN.
If you choose to use Lynx, the system startup procedure asks whether you
want to start Lynx now.
A.
Type
Y
(yes) to start Lynx.
B.
Choose Config (the default).
C.
Follow the procedures under Step 4 and Step 5 (below).
NOTE:
You can start Lynx at any time by entering
lynx
at the
command prompt.
Step 4—Entering Initial Interface Information
A.
Select the interface you want to use to access Voyager to
configure the NAP over a LAN. System startup displays the physical
IDs of the NAP’s interfaces. For the IP110 NAP, the display looks
something like Figure 3-3:
Select an interface from the following for
configuration:
1)eth-s1p1
2)eth-s2p1
3)eth-s3p1
Enter choice [1-4]:
Figure 3-3. System startup interface screen for IP110 NAP