Nokia 6090, Руководство по управлению

Страница: 14 / 84

Nokia 6090 AT Command Set 12
&W Store Configuration
This command stores the current settings to one of two user profiles. Command
parameters that are stored to a profile are the same as listed under the command &F
(see page 11) except the parameters of the following commands which are not
stored: +CMOD, +CSCA, +CSMP. (De facto.)
Syntax:
AT&W[0] Store settings to user profile 0.
AT&W1 Store settings to user profile 1.
Please note that AT&W is not supported so as to save previously used baudrate.
Appropriate AT command to set the baudrate has to be sent each time the Nokia
6090 is started.
The Antenna Motor Control line (AMC) can give an indication to an external device
that the 6090 is powered on, then the device can send the appropriate AT-command
in order the Nokia 6090 to switch to 9600 bps again.
&Y Select Power-Up Configuration
This command defines from which user profile (0 or 1) parameters are loaded when
the Nokia 6090 is activated. This setting is not included in the settings that are stored
in a user profile. The command &F does not affect this setting. (De facto.)
Syntax:
AT&Y[0] Parameters are loaded from user profile 0.
AT&Y1 Parameters are loaded from user profile 1.
+++ Escape
During on-line data state, the online command state can be entered by giving three
same characters in a sequence. The character is defined by S-register S2. The
default character is '+'. Before and after the sequence there must be a pause of at
least the time defined by S-register S12. By setting S12 to zero, escape sequence
detection can be disabled. (De facto.)
Syntax:
+++ Enter on-line command state.
'+' is default character.