www.noirot.com.au
3
For maximum efficiency, this heater is to be
wall mounted between a minimum height of
100mm and a maximum height of 150mm off
the floor. This is to allow the necessary
volume of air to flow freely through the vents.
It is also important to allow a minimum of
100mm clearance at the top and sides of the
heater and 500mm from the front (Fig. 2) so
as not to force the air back into the heater
and activate the Over Temperature Safety
Thermal Cut-Out Switch.
WARNING: IN
ORDER
TO
AVOID
OVERHEATING,
DO
NOT
COVER THE HEATER
If the “Over Temperature Safety Thermal Cut-Out Switch” is activated, the heater will
automatically switch off to limit the temperature to a safe value. To reset the thermal cut-out,
simply switch the heater off, unplug it from the power point and remove the obstruction(s). Plug
the heater back in and switch it on. The thermal cut-out switch will reset after a few minutes and
the heater will function normally.
PANEL LOCATIONS
This heater is suitable for use in all rooms including Zone 2 in Bathrooms (Fig.3) in accordance
with AS/NZS 3000: 2000 (Wiring Rules). Although this heater is double insulated and does not
require earthing,
for use in the bathroom it must be located so that the controls cannot be
touched by a person in the bath or shower.
Fig. 3
Fig. 2
