Nobis A10 C PLUS QUADRA, Инструкция по установке, эксплуатации и обслуживанию

Страница: 10 / 36

Use and Maintenance Manual model “A10V - A10C PLUS QUADRA”
10
ENGLISH
3.7 DOCUMENTATION TO ISSUE
When installation is concluded, the installation tech-
nician must deliver to the user:
• the use and maintenance booklet of the appli-
ance supplied by the manufacturer;
• the technical documentation of the accessories
used and subject to maintenance;
• the documentation relevant to the evacuation
system of combustion products;
• The system booklet (where planned);
• the documentation certifying installation;
The useful documentation for installation liability
must include:
• a detailed description (also including photo-
graphs) of the presence of other heat generators;
• Declaration of Conformity of the system
to standard (M.D. 37/08);
• general description, or diagram or
photographic documentation of the changes
made to the system, if intervention was necessary
during installation;
• Use of certified material with the CE mark
(305/2011);
• possible instructions relating to the warranty;
• the date and signature of the installation techni-
cian;
NOBIS SRL cannot be held in any way liable in the
event of non-compliance with the installation and
start-up standards of its products.
3.9 ELECTRICAL CONNECTION
The product power supply cable must only be con-
nected after concluding installation and assembly
of the product, it must not be in contact with hot
parts and must remain accessible after installation.
To carry out electrical connection, proceed as de-
scribed below:
• connect the power supply cable on the back
of the appliance;
• connect the cable plug to the
current socket on the wall.
You can connect an outer thermostat with timer to
the appliance for its regulation or to switch on and
off. For connection and management of the “outer
thermostat” function, refer to the specific chapter
in the following pages of this
manual.
3.8 UNPACKING THE PRODUCT
Packaging is composed of box-
es in recyclable cardboard ac-
cording to the RESY standards
and wooden pallets. All pack-
aging materials can be re-used
for similar use or, if necessary, dis-
posed of as urban waste, in com-
pliance with legislation in force.
Remove the strap binding the
pallet to the packaging and lift
the cardboard; remove the plas-
tic bag around the product,
ensuring it is intact.
The body must always be
moved in a vertical position using
trolleys.
Pay particular attention
so that the door and its glass are
protected against mechanical
impact which would compro-
mise their integrity.
If possible, unpack the
product near the area where it
will be installed.
To remove the appliance from the pallet, you can
remove the two screws placed under the pallet (13
hex key) to release the appliance from the wooden
base.
Position the equipment and proceed with its
connection to the chimney flue. Find,
using the 4 adjustment feet, the right level so that
smoke discharge and the pipe are connected
correctly.